1. A thin pin of iron can be made to float on water (drinking) in a bowl.

A thin pin of iron can be made to float on water (drinking) in a bowl. This phenomenon is due to the

surface tension of water
viscous nature of water
presence of ionic bonds in water molecules
presence of covalent bonds in water molecules
This question was previously asked in
UPSC CAPF – 2012
A thin pin of iron, despite being denser than water, can float on the surface of water due to surface tension. Surface tension is the property of liquid surfaces that causes them to behave like a thin elastic membrane, resisting external force. The cohesive forces between water molecules create this tension.
– Surface tension is a property of liquids arising from cohesive forces between molecules.
– It allows the liquid surface to support small objects that are denser than the liquid, provided the object is placed gently and does not break the surface.
Viscosity is a measure of a fluid’s resistance to flow. Ionic and covalent bonds describe the chemical bonding within water molecules, not the macroscopic phenomenon of an object floating on the surface. The ability of insects like water striders to walk on water is also due to surface tension.

2. A microwave oven uses wave with a

A microwave oven uses wave with a

large wavelength in the invisible range
small wavelength in the visible range
large wavelength in the visible range
small wavelength in the invisible range
This question was previously asked in
UPSC CAPF – 2012
A microwave oven uses microwaves, which are electromagnetic waves. Microwaves have wavelengths that are longer than visible light, infrared, and ultraviolet radiation, but shorter than radio waves. They fall within the radio spectrum and are invisible to the human eye. Therefore, they have a small wavelength relative to radio waves but are definitely in the invisible range. Compared to visible light, their wavelength is larger, but option D specifies ‘small wavelength in the invisible range’, which is correct relative to, say, radio waves or considering the typical options comparing ‘visible’ vs ‘invisible’ and relative wavelength size.
– Microwaves are part of the electromagnetic spectrum.
– They are invisible to humans.
– The wavelengths are typically in the centimeter range.
Microwave ovens commonly operate at a frequency of 2.45 GHz, which corresponds to a wavelength of approximately 12.2 cm. This wavelength is efficient at heating water molecules in food.

3. A television remote uses

A television remote uses

infrared waves
cosmic waves
microwaves
ether waves
This question was previously asked in
UPSC CAPF – 2012
Most traditional television remote controls use infrared (IR) light to send signals to the television. These signals are invisible to the human eye.
– Infrared waves are a type of electromagnetic radiation with wavelengths longer than visible light.
– IR communication is suitable for short-range, line-of-sight applications like remote controls.
Newer types of remote controls, particularly for smart TVs or other devices, may use radio waves (like Bluetooth or Wi-Fi) which do not require a direct line of sight. However, the vast majority of standard TV remotes use infrared.

4. Wi-Fi in a computer implies

Wi-Fi in a computer implies

wired local area network
wireless local area network
high fidelity
high efficiency
This question was previously asked in
UPSC CAPF – 2012
Wi-Fi is a technology that enables wireless communication within a local area network (LAN). It is based on the IEEE 802.11 family of standards.
– Wi-Fi stands for Wireless Fidelity (though this is not a formally recognized term by the Wi-Fi Alliance).
– It creates a Wireless Local Area Network (WLAN).
– Used for connecting devices to a network wirelessly over short to medium distances.
Wi-Fi is the most common technology used for accessing the internet wirelessly in homes, offices, and public spaces. It operates on radio waves, typically in the 2.4 GHz and 5 GHz frequency bands.

5. Consider the following statements about the Indian Constitution : 1.

Consider the following statements about the Indian Constitution :

  • 1. In addition to the structure of the Government, it has also concerned itself with some aspects of a desirable civil society and economy.
  • 2. Through amendments in the year 1976, it has also outlined the fundamental duties of citizens along with their rights.

Which of the statements given above is/are correct?

1 only
2 only
Both 1 and 2
Neither 1 nor 2
This question was previously asked in
UPSC CAPF – 2012
Statement 1 is correct. The Constitution not only lays down the structure of the government (Union and State executive, legislature, judiciary) but also includes parts like Fundamental Rights (Part III) which define aspects of a desirable civil society by guaranteeing basic freedoms and protections, and Directive Principles of State Policy (Part IV) which outline goals for the state regarding social and economic justice, aiming towards a desirable economy and society. Statement 2 is also correct. Fundamental Duties (Part IVA, Article 51A) were added to the Constitution by the 42nd Amendment Act in 1976. This addition outlined the fundamental duties of citizens, complementing the fundamental rights already present in the Constitution.
– Part III (Fundamental Rights) and Part IV (DPSP) relate to aspects of civil society and economy.
– Part IVA (Fundamental Duties) was added by the 42nd Amendment Act, 1976.
– The Constitution provides a framework for governance as well as societal goals.
The 42nd Amendment Act, 1976, was a comprehensive amendment that made several changes to the Constitution, including adding the words ‘Socialist’, ‘Secular’, and ‘Integrity’ to the Preamble and incorporating the Fundamental Duties based on the recommendations of the Swaran Singh Committee.

6. Consider the following statements about Indian elections : 1. The Co

Consider the following statements about Indian elections :

  • 1. The Constitution provides that elections to the House of the People and the Legislative Assemblies of States are to be held on the basis of universal adult suffrage.
  • 2. The Constitution stipulates that there will be separate electoral rolls for Parliamentary and State Assembly elections.

Which of the statements given above is/are correct?

1 only
2 only
Both 1 and 2
Neither 1 nor 2
This question was previously asked in
UPSC CAPF – 2012
Statement 1 is correct. Article 326 of the Constitution of India explicitly states that elections to the House of the People and the Legislative Assemblies of States shall be on the basis of adult suffrage. Statement 2 is incorrect. Article 325 of the Constitution provides for a single general electoral roll for every territorial constituency for election to either House of Parliament or to the House or either House of the Legislature of a State. It prohibits separate electoral rolls based on religion, race, caste, sex, or any of them.
– Article 326: Universal Adult Suffrage for Lok Sabha and State Assembly elections.
– Article 325: Provisions for a single general electoral roll.
– The Election Commission of India is responsible for the preparation of electoral rolls.
Universal adult suffrage means that every citizen of India who is not less than 18 years of age and is not otherwise disqualified under the Constitution or any law on grounds of non-residence, unsoundness of mind, crime, or corrupt or illegal practice, is entitled to be registered as a voter in any such election. The system of a single electoral roll aims to prevent discrimination and ensure integrated elections.

7. Consider the following statements: They are a subset of Council of M

Consider the following statements:

  • They are a subset of Council of Ministers.
  • The scrutiny of Legislative and Constitutional Amendment Bills gets done in these Committees.

Which of the statements given above is/are correct?

1 only
2 only
Both 1 and 2
Neither 1 nor 2
This question was previously asked in
UPSC CAPF – 2012
Statement 1 is incorrect because Parliamentary Committees are composed of Members of Parliament (MPs) from different parties, not necessarily a subset of the Council of Ministers. Ministers may be members of some committees, but the committees are not defined as a subset of the Council of Ministers. Statement 2 is correct as parliamentary committees, such as Select Committees or Joint Committees, are routinely involved in the detailed scrutiny of various bills, including legislative and constitutional amendment bills, referred to them by the House.
– Parliamentary Committees are parliamentary bodies formed to perform specific functions delegated by the Parliament.
– They play a crucial role in the legislative process, including the scrutiny of bills.
– The Council of Ministers is the executive body, headed by the Prime Minister.
Examples of committees that scrutinize bills include Departmentally Related Standing Committees, Select Committees (formed for a specific bill), and Joint Committees (with members from both Houses). While ministers are part of the government and may interact with committees, the committees themselves are organs of Parliament, distinct from the Council of Ministers.

8. The constitutional principle of the ‘Basic Structure’ was invented by

The constitutional principle of the ‘Basic Structure’ was invented by the

Executive
Judiciary
Legislature
Civil Society
This question was previously asked in
UPSC CAPF – 2012
The constitutional principle of the ‘Basic Structure’ was evolved and established by the Judiciary, specifically the Supreme Court of India.
– The doctrine was laid down by the Supreme Court in the landmark case of Kesavananda Bharati v. State of Kerala in 1973.
– This principle holds that the Parliament’s power to amend the Constitution under Article 368 is not unlimited and cannot alter the basic structure of the Constitution.
While the Executive and Legislature are involved in the process of governance and law-making, the interpretation of the Constitution and the establishment of principles like the Basic Structure falls under the purview of the Judiciary. Civil Society plays a role in advocating for rights and influencing public opinion but does not invent constitutional principles in this manner.

9. Three dice, whose all six faces are marked ‘1’ to ‘6’, are thrown. The

Three dice, whose all six faces are marked ‘1’ to ‘6’, are thrown. The number of ways of getting a sum of 16 is

3
4
6
12
This question was previously asked in
UPSC CAPF – 2012
The number of ways of getting a sum of 16 when three dice are thrown is 6.
We need to find the number of ordered triples (a, b, c) such that a + b + c = 16, where a, b, and c are integers between 1 and 6 (inclusive).
Let’s list the possible combinations (unordered sets of numbers) that sum to 16, where each number is between 1 and 6:
– The maximum sum of two dice is 6+6=12. So the minimum value on one die to reach a sum of 16 must be 16 – 12 = 4.
– Possible combinations (sorted):
– If the lowest value is 4: 4 + ? + ? = 16. The remaining two numbers must sum to 12. The only way to get 12 with two dice is 6 + 6. So, the combination is {4, 6, 6}.
– If the lowest value is 5: 5 + ? + ? = 16. The remaining two numbers must sum to 11. Ways to get 11 with two dice are 5 + 6 or 6 + 5. So, the combination is {5, 5, 6}.
– If the lowest value is 6: 6 + ? + ? = 16. The remaining two numbers must sum to 10. Ways are 4+6, 5+5, 6+4. The combinations are {6, 4, 6}, {6, 5, 5}, {6, 6, 4}. Note that {6,4,6} is the same combination as {4,6,6}, and {6,5,5} is the same as {5,5,6}. We have already listed the unique combinations: {4, 6, 6} and {5, 5, 6}.

Now, we count the number of distinct permutations (ways) for each combination:
– Combination {4, 6, 6}: The possible outcomes when rolling three dice are (4, 6, 6), (6, 4, 6), and (6, 6, 4). There are 3 distinct permutations. (Using the formula for permutations with repetitions: 3! / 2! = 3).
– Combination {5, 5, 6}: The possible outcomes are (5, 5, 6), (5, 6, 5), and (6, 5, 5). There are 3 distinct permutations. (Using the formula for permutations with repetitions: 3! / 2! = 3).

Total number of ways = 3 (for {4, 6, 6}) + 3 (for {5, 5, 6}) = 6.

Listing out combinations and then calculating permutations is a systematic way to solve such problems. For larger numbers of dice or higher sums, more advanced techniques involving generating functions might be used, but for small cases like this, enumeration is feasible.

10. The average of x, y and z is 30, and the average of x and y is 20. Wha

The average of x, y and z is 30, and the average of x and y is 20. What is the value of z?

10
20
40
50
This question was previously asked in
UPSC CAPF – 2012
The value of z is 50.
The average of a set of numbers is the sum of the numbers divided by the count of the numbers.
Given: Average of x, y, and z is 30.
This means (x + y + z) / 3 = 30.
Multiplying both sides by 3, we get: x + y + z = 30 * 3 = 90. (Equation 1)
Given: Average of x and y is 20.
This means (x + y) / 2 = 20.
Multiplying both sides by 2, we get: x + y = 20 * 2 = 40. (Equation 2)
Now substitute the value of (x + y) from Equation 2 into Equation 1:
40 + z = 90.
To find z, subtract 40 from both sides:
z = 90 – 40
z = 50.
This is a straightforward problem involving the definition of average and solving a simple linear equation. Understanding how to translate average information into sums is key.