l0Mhz
25Mhz
50Mhz
100 Mhz E. None of the above
Answer is Right!
Answer is Wrong!
Computer Hardware
2. What could cause a fixed disk error? A. CDROM drive not installed B. Incorrect CMOS settings C. Incorrect RAM settings D. All of the above E. None of the above
CDROM drive not installed
Incorrect CMOS settings
Incorrect RAM settings
All of the above E. None of the above
Answer is Right!
Answer is Wrong!
3. To find out how much memory is available, you could type _____ A. EMM B. MEM C. CHKDSK D. MEMMAKER E. None of the above
EMM
MEM
CHKDSK
MEMMAKER E. None of the above
Answer is Right!
Answer is Wrong!
4. You are testing the resistance in Ohms of a fuse on a 2 amp system. If the fuse is good, the meter should read? A. 0 B. 0.2 C. 5 D. 2 E. None of the above
0
0.2
5
2 E. None of the above
Answer is Right!
Answer is Wrong!
5. The standard IRQ for the floppy drive is? A. 9 B. 6 C. 10 D. All of the above E. None of the above
9
6
10
All of the above E. None of the above
Answer is Right!
Answer is Wrong!
6. A keyboard locks up intermittently even when replaced with a new keyboard. What is the LEAST likely cause of the problem? A. A second bad keyboard B. The keyboard controller chip C. The keyboard connector D. The motherboard E. None of the above
A second bad keyboard
The keyboard controller chip
The keyboard connector
The motherboard E. None of the above
Answer is Right!
Answer is Wrong!
7. Current is measured in units of: A. volts B. amps C. ohms D. farads E. diodes
volts
amps
ohms
farads E. diodes
Answer is Right!
Answer is Wrong!
Detailed SolutionCurrent is measured in units of: A. volts B. amps C. ohms D. farads E. diodes
8. MSD exe does not have information on: A. cache B. video C. operation system D. com ports E. None of the above
cache
video
operation system
com ports E. None of the above
Answer is Right!
Answer is Wrong!
9. What command is used to hang up a MODEM when using the “AT Command set”? A. ATZ B. ATD C. ATR D. ATH E. None of the above
ATZ
ATD
ATR
ATH E. None of the above
Answer is Right!
Answer is Wrong!
10. When configuring is a network interface cards without jumpers or plug and play, what is used to set the IRQs? A. DMA B. CMOS C. the OS D. configuration software E. None of the above
DMA
CMOS
the OS
configuration software E. None of the above
Answer is Right!
Answer is Wrong!